Advance Adapters Adapter Plate Kit For GM NP205 (10 Spline Transfer Case) To GM 4WD NV4500 Replacing a SM465 This package is for a GM 4WD NV4500 to the GM 10 spline NP205 (1971-85). This application requires the shortening of the New Venture output shaft to 4.498 inch in length. When using this kit, we couple to the 31 spline area which in under the harmonic balancer. in order to cut the shaft, you will need to remove the GM tailhousing. The NP205 has a 10 spline male shaft. We manufacture a female coupler that engages the 31 spline transmission to the 10 transfer case. We have included a new seal for the adapter housing along with a new sealed bearing for the transfer case for extra protection. This transfer case adapter kit uses two castings to couple the NV4500 to the NP205. These castings have been mashined to allow for proper transfer case shift rail clearance. A shifter bracket has been provided to mount the stock NP205 shifter handle; however, you may be required to modify the handle to properly fit up into the cab of the truck. The bellhousing in this kit bolts directly to the front of the NV4500. Depending on the type of clutch linkage your vehicle has, we offer two brackets to assist you. The kit comes with 715534, which is a bracket for the mechanical linkage. This bracket provides a pivot point on the bellhousing similiar to the pivot found on a stock GM bellhousing. Some mechanical linkages use a pivot point off of the engine block which would remain the same. If your vehicle was equipped with a hydraulic linkage, we also offer a slave cylinder bracket that bolts to our bellhousing, 715535. This bracket is designed to fit 1985-91 GM slave cylinders. You can substitute 715534 with 715535 when ordering this complete kit. The SM465 is 12 inches long with an adapter housing of 7.250 inches. The transmission and transfer case adapter length is approximately 19.250 inches. The overall length of the adapter kit is approximately 1 inch longer that the stock; therefore, driveline modifications may be necessary. The overall length assembled including the bellhousing is 26.250 inches. Kit Includes: - 50-0217 - Transfer case adapter
- 702576 - Bellhousing kit for GM NV4500 (1996 and newer)
- 715534 - Clutch linkage bracket
- 716050C - Shifter handle assembly
|
